Valve-to-tank sealing O-ring for Swing Plus

5,72 €

+57 points in “Joy Club” +1 000 bonus points on the second online purchase · terms

An original O-ring that seals the joint between the multiport valve and the body of the Swing Plus 10, 14 or 18 sand filter.

  • Compatible with Swing Plus 10, 14 and 18
  • Mountfield factory part with code MT06111
  • Quick replacement, suitable for preventive maintenance

Frequently bought together

Total for selected:

Description

Two parts meet at this spot – the valve and the filter tank. The O-ring between them is a rubber seal: once it softens, ages or deforms, water starts to drip. The original Mountfield ring has the exact size and profile for the Swing Plus series.

Data

Part numberMT06111
BrandMountfield
Typevalve / tank sealing ring
For modelsSwing Plus 10, 14 and 18

For which units

  • 3BTE0513 – Swing Plus 10 model
  • 3BTE0514 – Swing Plus 14 model
  • 3BTE0515 – Swing Plus 18 model

Why it wears out

The joint is taken apart during repairs, when the sand is replaced and for winter storage. Every opening puts strain on the seal, which loses its elasticity and stops sealing. The new ring sits tightly in its groove, so the connection stays dry and reliable.

  • seals the valve–tank joint
  • flexible ring that fits tightly
  • original Mountfield product

What you gain

The size, cross-section and elasticity are chosen for the specific model, so there is no need to try similar rings. This avoids leaks that later lead to a more expensive repair. With the code noted down, you can be sure the part matches.

Replacement

Stop the pump and release the pressure in the filter. Remove the clamp, lift the valve, take out the old seal and clean the groove. Fit the new ring, put the valve back in place and tighten the clamp. Finally, check for leaks.

Tips for seals

It is a good idea to replace them preventively, for example before the start of the season. Lightly moisten them with water or a drop of silicone grease for pools before assembling. Do not use mineral-based oils, as they corrode the rubber. Keep spare seals in the dark, at room temperature.

How to make sure it is your part

Find the code of your unit (for example, starting with 3BTE) and compare it with the list above. If it matches, MT06111 is the right choice. If in doubt, send us a photo of the worn seal and the model of your filter. While you are disassembling, look at the surrounding parts too: it is sensible to replace worn ones at the same time.

The seal serves the joint between the six-way valve and the tank on Swing Plus 4 m3/h. More consumables are available in the filter and equipment parts.

See also: Wellness, Pools and Equipment, Spare and Other Parts, Pool Spare Parts, For Filters and Other Equipment, For Prefabricated Pools, Pool Liners, Pool Underlays.

You may also like

More from Mountfield

Newsletter

News, promotions and ideas for home and garden

Subscribe to our newsletter to receive news about promotions, new products and other useful information.