Description
If the hose between the filter and the pump cracks, the filtration stops working properly. This is the factory hose for the Clear (2 m³/h) sand model: white, corrugated and flexible, with dimensions of 32 mm in diameter and 0.7 m in length.
Technical specifications
| Intended for | Clear filter, 2 m³/h, sand |
|---|---|
| Total length | 0.7 m |
| Hose diameter | 32 mm |
| Product type | hose |
| Brand | Mountfield |
| Item number | BWP6132 |
Compatibility
- 3BTE0398 (Clear, sand filtration, 2 m³/h)
The Clear connector and union nut are ordered together with it. Also take a look at the other filter parts and the sand filters themselves.
When to replace it
Every season the hose is bent and put under strain. Over time it splits or softens, and then the connection leaks or draws in air. A visible crack or lack of flexibility means it is time for a new one.
Advantages of the original hose
- the ends fit the filter connections exactly
- the length is sufficient without sharp bending
- easy to identify by the manufacturer code
- fewer repeat repairs
Installation
- Unplug the pump from the power supply.
- Release both ends of the worn hose.
- Wipe and inspect the connection points.
- Fit the new one and tighten at both ends.
- Switch on the pump and check for leaks.
Tips
Always disconnect the power before working on the unit. Tighten the connections evenly and without excessive force, and keep the old part until the check is finished. At the start of the season, inspect the seals and connections to find small problems in good time.
See also: Wellness, Pools and Equipment, Spare and Other Parts, Pool Spare Parts, For Filters and Other Equipment, For Prefabricated Pools, Pool Liners, Pool Underlays.
